Operation Manual

Simrad PI54

244

850-165186 / Rev.B

Data Update Rate

This parameter is used to select an interfaced sensor’s data

update rate.

Note: This is a key parameter. Unless the data update rate defined in

the sensor matches the rate defined on the host PI system, the

communication will not work!

The data update rate is the time interval between individual

transmissions from the sensor containing measurement data. The

rate selected must match the corresponding setting in the PI

Cabinet’s Setup window.

Operation

To operate, click the spin box next to the Data Update Rate

label. Select the desired rate. Then, click the Configure Sensor

button to program the interfaced sensor with the new data

update rate parameter. Finally, check that the message field is

updated with the new parameter, and that the message Success!!

is displayed at the bottom as confirmation that the command

was executed.