Operation Manual

PI Configurator
245
850-165186 / Rev.B
Establish Communication With Sensor
This button i nitiates contact between the computer and a well
charged sensor by sending it a ”wake-up” command.
Once two -way communication is established the following
occurs:
• The indicator lamp (in the lower right-hand corner of the
dialogue) will be turned on and off every two seconds.
• The LED inside the interfaced sensor will illuminate every
two seconds.
• The sensor will download its current configuration data to the
PC. The information is shown in the message field.
Operation
To operate: click the Establish Communication with Sensor
button. Check that the message field shows the interfaced
sensor’s current configuration parameters, and thate the message
Success!! is displayed as confirmation at the bottom of the text.
To terminate the communication with the sensor, click the
Terminate Communication button.