Operation Manual

Simrad PI54
256
850-165186 / Rev.B
Sensor Type
This parameter is to be configured in accordance with the
sensor’s label and can only be accessed in the Professional
mode.
The dialogue box is used to select which of the sensor’s internal
programs to run when activated. When using the PI
Configurator in the Standard mode, it will only display the type
of sensor interfaced.
It is not possible to change a sensor’s type.
Operation
To operate, click the Sensor Type dialogue box and drag the
slider bar to the type of sensor written on its label. Then, click
the Configure Sensor button to program the interfaced se nsor
with the new parameter. Finally, check that the message field is
updated with the new parameter, and that the message Success!!
is displayed at the bottom as confirmation that the command
was executed.