Operation Manual

Simrad PI54
258
850-165186 / Rev.B
Show Channel At Startup
This dialogue box controls weather or not the interfaced sensor
will flash a channel identification code using its internal LE D
when first energized.
When Enabled is selected, the sensor will flash its presently
configured communication channel number at startup when in
the normal mode (not in the charge or communication modes).
This feature may also be activated by touching a sens or’s lid and
charging lug simultaneously.
When activated, the sensor will respond by flashing its
individual LED identification codes, as follows:
(1) = One long flash: It has a duration of approximately 1
second.
(2) = One start flash: This signals that the first digit of the
channel number is next.
(3) = None, one, two or three short flashes: The number of short
flashes signifies the first digit of the configured channel number.
(4) = A second start flash: This signals that the second digit of
the channel number is next.
(5) = None to nine short flashes: The number of short flashes
signifies the second digit of the configured channel number.
Operation
To operate, use the spin box and choose Enable or Disable.
Then. click t he Configure Sensor button to program the
interfaced sensor with the new parameter. Finally, check that the
message field is updated with the new parameter, and that the
message Success!! is displayed at the bottom as confirmation
that the command was executed.