Operation Manual

Sensor test procedures
265
850-165186 / Rev.B
SENSOR TEST PROCEDURES
Overview
Using the PI Configurator application, you can test the
operational status of each sensor. In the following, you will find
the test procedures. Note that PI and PS sensors are tested using
the same procedures.
Topics
→ Bottom Contact sensor, test procedure, page 266
→ Catch & Rip sensors, test procedure, page 273
→ Depth sensor, test procedure, page 276
→ Height sensor, test procedure, page 282
→ Spread & Remote sensors, test procedure, page 269
→ Temperature Sensor, test procedure, page 279
Sea water switch design change
The sea water switch design on all the PI sensors was changed
in 2005. On sensors produced after the design change, the sea
water switch is comprised of a sacrificial brass bolt. This bolt
must be replaced when and if it is worn. A dedicated procedure
is provided in the PI System operator manual.