Operation Manual

Display modes

850-165186 / Rev.B

Highway display

The navigation display provided by the PI54 offers all key

information related to waypoint navigation. Note that the

information provided by this presentation assumes that you have

the relevant sensor (GPS) connected to your PI54 system.

The navigation display can be set up as a full screen feature, but

you can also set it up to be displayed in smaller windows.

The following information is

provided by the navigation

display:

(A) “C” is the current course

over ground, while “B” i s the

course to the next waypoint.

(B) “X” is the cross-track error,

while “D” is the distance to the

next waypoint.

over ground, while “V” is the

speed towards the next

waypoint.

(D) These are the crosstrack

error alarm lines.

(E) The ideal course line

between the two waypoints.

To change presentation parameters

The presentation is controlled by the parameters defined in the

PI54 setup. To change these parameters, press the ADJ or ENT

button to open the Navigation setup page.

To access the Pilot/Position parameters, press the MENU

button to access the main menu. Then. select Pilot/Position

Setup on the Setup menu.