Installation manual

Simrad SP70
184
850-164186 / Rev.D
The SP70 hull unit provided before January 2004 is lubricated
with the types of oil or grease as specified below. However, if of
equal quality, other types may be used. The numbers refer to the
lubrication points on the illustration to the left.
(1) The ball bearing on the top of the hoist/lower
screw must be lubricated with normal ball bearing
grease.
(2) The hoisting spindle should be lubricated with
Tonna Slideway Oil S68.
(3) Topping up the shaft sleeve is only required if
the shaft is dry of lubrication, or if water tends to
force its way up along the shaft. The shaft sleeve is
filled with Esso Cazar K1.
(A) = Air bleeding cock