Operation Manual

The other end of the cable has a prewired connector block that

locates in the next available free station in the VHF black box.

Please refer to your VHF user manual for further instructions (Fig.

2.2).

The radio can also be fitted with a Simrad LS80 external speaker

or third party speakers with an impedance of 4 Ohms. If an

external speaker is to be fitted this must be wired directly into the

connector block. Remove the wires from the connector block

terminals 7 and 8 and insulate the bare ends. These wires are are

redundant and not used. Wire the external speaker into the two free

terminals.

Note The Basestations VHF cable must not occupy the connector in the

VHF black box that is designated Station 1. Station 1 must be

connected to a hardwired VHF Handset or Control Panel.

Installation

Terminal

Number

Wire

Colour(s)

Brown

Green

Red

White

Blue

Yellow

Orange

Black

Fig. 2.2 - Terminal wiring