Application Guide

2 3
Thread tension dial
Presser foot lifter
Thread take-up lever
Thread guide 2
Thread guide 1
Hole of bobbin pin
for winding
Handwheel
ON/OFF Button
Handle
Thread guide 3
Thread guide 4
Needle clamp screw
Needle plate
Bobbin case
cover
Bobbin case
& Bottom bobbin
Needle
TO REPLACE BATTERIES (4AA not included)
Caution: Make sure device is in the Off position prior to battery replacement.
Insert 4 AA batteries into the battery compartment on
the bottom of the machine. Put batteries in, following the
correct polarities marked on the machine or following
the diagram. Replace all 4 AA batteries as a simultaneous
set as shown.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon - zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
TO USE AC/DC ADAPTER (not included)
Make sure the device is in the OFF position. Connect the
AC/DC adapter plug into the machine plug socket then
into an AC/DC receptacle.
Adapter must be 6V 1000mA. Adapter must use plug
with 1/8 in/3.5 mm diameter. Plugging an adapter into a
portable device that has different ratings could damage
the device and adapter. Be sure to set the adapter’s tip
polarity to conform to the diagram shown:
Caution: Remove batteries from machine when sewing
with adapter to prevent possibility of batteries over
charging and exploding or leaking.
IMPORTANT NOTES TO BE READ
PRIOR TO FIRST USE
1. When operating device for the first time, run for 10 seconds and then pause for 5
seconds. It can then be used again regularly.
2. Lift presser foot and pull out test material. Cut the thread close to the test material.
SEWING
1. Lift up the presser foot (A) and
raise needle by turning the
handwheel toward the back of the
machine (B).
2. Make sure both thread ends are
pulled 4 inches back behind the
needle (C).
3. Put the fabric under the presser
foot and lower the needle. Then
lower the presser foot (D).
4. Press and release the power button (E) to start
sewing. When complete, press and release power
button to stop sewing.
5. VERY IMPORTANT: WHEN FINISHED, PULL UPPER
THREAD LOOSE BY HAND TO PREVENT THE NEEDLE
FROM BENDING WHEN REMOVING THE FABRIC.
6. Raise the needle (F) and presser foot (G) and pull the
fabric toward the back. Then cut both threads about 4
inches from the edge of the fabric.
CONTROLLING THE SPEED
Press in the speed button — speed will get faster.
Press it again — speed will be normal.
Large spool pin
for winding
Bobbin pin
for rewinding
Bobbins
Threader
Needle
+
+
–
–
Adapter
plug
socket
A C
D
E
F
G
B
Speed
Normal
Faster Speed
Normal Speed