Instruction Manual

Procedure. Set Selector (AL) and Width Lever (see page 42). Place work under needle, aligning centre

marking of buttonhole with centre score line of Special Purpose Foot.

BUTTONHOLES (Cont'd.)

® ''i .

,,..v

Side Stitching. Position needle in fabric at point A. Lower foot and stitch to end of marking. Leave

needle in fabric at point B. Raise foot and pivot work on needle. Lower foot. Take one stitch without

changing Width setting, bringing work to point C.

Bai Tack. Adjust Stitch Width for bar tacks and take no less than six stitches. Stop at point D.

Side Stitching. Readjust Stitch Width for side stitching. Complete work to point E. Leave needle in fabric.

Final Bar Tack. Adjust Stitch Width for bar tacks, and take no less than six stitches in reverse, ending

at point F.