Owner's manual

CHANGING
DIRECTION OF SEWING:
• Before changing direction,
stop the machine at the desired
point making sure that the
needle is down through the
fabric.
• Raise ttre presser foot, turn
the fabric to the desired posi
tion, lower the presser foot
and continue sewing.
Note: When sewing with a twin
needle, it is necessary to raise
the needles above the fabric
before turning. Be cautious to
realign the fabric to the position
where the last stitch ends.
REMOVING
THE MATERIAL:
After stopping the machine,
turn the hand wheel toward you
until the take up lever is at its
highest position.
Raise the presser foot, then
draw the fabric gently to the
left rear of the machine, making
sure that the threads are under
the foot. This avoids bending
the needle.
With two hands, lift the two
threads up and into the thread
cutter on the presser bar and
pull down firmly to cut the
threads.
17
CROSSING
HEAVY SEAMS:
When crossing heavy seams,
angle the fabric down into the
foot so that the foot can draw
the heavy area into the feeding
mechanism and pass over the
bulk easily.