Owner's manual

CHANGING THE NEEDLE
Flat Bide
• Afways make sure needle is
sfratghf.
If straightness of
needle, lay needle on a flat
SiM is
fn parallel as shown
in above diagram.
- Needle
Clamp Screw I
Plat side towards
back of machifie
• Turn hand wheel toward you to
posmCr'"‘’"^‘°‘‘^^‘9hest
• Loosen needle clamp screw
f''"«die as
back of ml '® 'awards
P„ .K °fj^3chine as shown
in the above diagram.
Tighten needle clamp screw
With screwdriver.
Follow the same procedure for
insertion of twin needle.
To make sure that needle has
h®®!] '^^^'■ted correctly turn
cfrth^P®®* •°'^ard you and
throlioh ,h®®^'®
nofw|9h the center of the
needle hole in the needle plate
Stitch selector dial must be set
®,f"'9ht stitch needle posi
Xnmem."'’""'^‘"^ ®®®‘^'®
^ skipped stitches occur, needle
may be incorrectly inserted.