Installation Guide

Bathtubs:Rough-InWasteDrain
The copper bathtub rough-in kit not only makes installation easier,
butitsavestimeandmoney.Designedtoworkspecicallywith
Sinkology copper bathtubs, and is protected by a lifetime warranty.
1. Final waste drain and waterline rough-in’s should be completed
andooringshouldbenished.Ensurebathtubisproperly
supported and level.
2. Double check bathtub faucet installation requirements before
nalbathtubinstallation.
3. Apply thread sealant or plumbers tape to any threaded
connections that do not have rubber gaskets.
4. Applyplumbersputtytoundersideofdrainangeandthread
through the bathtub and into drain pipe.
5. Ensurewastedrainandoverowissecurelyconnectedto
bathtub.
6. Place tub back into desired location and verify that bathtub is
level. If using recommended rough-in kit (#ITD35), the tub will
needtobeliftedapproximately8”beforeloweringintonal
position.
7. Finish installation by running a bead of silicone adhesive
around the base of copper freestanding bathtub where
applicable to create a watertight seal.
8. Allow sealants and adhesive to thoroughly dry before
llingbathtubwithwater.Consultsealantandadhesive
manufacturers for dry times, as they may vary.
9. Register your new bathtub at sinkology.com/registration.
Important
Sinkology copper bathtubs are handmade so variations in dimensions can
occur.WerecommendperformingRough-Inprocedureswiththebathtub
on site to ensure the correct installation.
21
PRO
DIY