Installation Guide

Kitchen&BarSinks:Drop-In

Drop-in kitchen sinks are easy to install and are designed to install

beautifully in a wide range of countertop surfaces. Sinkology Drop-In

kitchen sinks make DIY kitchen renovations effortless and impactful.

Drop-In sinks can be used to replace an old sink or installed in

luxurious new countertops.

1. Flip sink upside down and trace the outside edge onto craft

paper or cardboard. Add a second line that is 1/2” inside that

line. Cut out the traced template using the second line.

2. Positionthetemplateatonthecountertopandalignwith

cabinet and plumbing connections.

3. Mark openings and cut the countertop.

4. Alwaysdoublecheckthesinkfortinsidetheholebefore

moving on.

5. If your sink does not come with mounting hardware, refer to

bath sink drop-in installation instructions on page 4.

6. Before dropping your new sink into the countertop for the last

time apply a thick bead of Sinkology antique brown or clear

neutral cure 100% silicone around the hole on the countertop

to form a water tight seal around the sink. See our Complete

SiliconeInstallationKit(#SINSTALL-101) for Copper Sinks.

7. Install hardware. Place

notched end of all bolts

into the keyhole slots. See

diagram. Lower the sink

carefully into the countertop

so the bolts enter without

interference.

Important

Not all Drop-In kitchen sinks require mounting hardware. If your

kitchen sink does not come with mounting brackets, we recommend

securing your sink with 100% silicone and expandable foam

(see bath sink drop-in instructions on page 4)

PRO

DIY