Installation Guide

Kitchen:FireclaySinks

Fireclay sinks are distinct and ready for heavy duty use. Fireclay is

coated in a high strength glaze which is resistant to scratches or stains.

Fireclay is a very dense material which makes each sink hard to chip

aswellasveryheavy.Werecommendusingatleasttwopeoplewhen

liftingthesink.Fireclaysinkswillrequireextrasupportandmodication

to existing cabinets.

Important

Sinkology Fireclay sinks require a solid support built into the cabinet and

recommendprofessionalinstallation.Werecommendanundermount

install with a frame supporting the underside of the sink.

5. Install a length of 2x4 vertically under each corner of the sink

base to create support legs directly under the sink.

6. The sink should rest 1/8”

inch below the top of your

cabinets, ensuring plenty

of clearance to countertop

installation. Use a level to

make sure the sink is even and

will drain correctly.

7. Place the sink in the support

structure. Apply a bead of

silicone sealant between the rim of the sink and the countertop

to create a watertight seal. Hook up the drain underneath

according to the drain instructions and the sink will be ready

for use. DO NOT overtighten your disposal drain, this could

damage your kitchen sink. Use plumbers putty to make a water

tight seal between the drain and the sink.

8. Cut the countertop with your template and install the

countertop. Apply a bead of silicone sealant between the rim of

the sink and the countertop to create a watertight seal.

9. Register your new sink at sinkology.com/registration.

1. Trace the rim of the sink on a piece of craft paper or cardboard.

Measure the distance between the edge of the basin and

theinsideedgeofthelip.Addasecondlineinsidetherst

according to this measurement. Cut on the second line to make

your cut out sheet.

2. Measure the front apron of the sink and cut the face of the

cabinet to allow the sink to slide in.

3. Install the sink support in the cabinet base. See steps 4 - 6.

4. Install two lengths of 2x4’s front to back in the cabinet base.

Build out the support structure and ledge for your Fireclay sink

to rest on.

PRO

DIY