Home Signal Distribution Kit Installation Guide

Slide one of the U-bolts through the holes at the top of the mounting bracket.

Then slide one of the mounting brackets over the two legs of the U-bolt.

Next, screw the hex nuts on each leg until they are snug. Do not yet tighten the

hex nuts beyond nger tight. Repeat this procedure with the other U-bolt. When

all the hex nuts are snug, verify that the antenna is facing the correct direction

and begin tightening each hex nut with a 3/8” wrench. Turn each hex nut one-half

turn and then move to the next hex nut repeating this one-half turn pattern until

all the hex nuts are equally tight. Tighten the hex nuts enough so that the anten-

na is secured to the mast or pole, but do not overtighten them.