Home Signal Distribution Kit Installation Guide

Disconnect the cable from the satellite dish LNB and connect it to the

COMBINED OUT port on the Combiner (SR2261) as shown. (Refer to

page 5 for the Combiner port identication.)

Using one of the RG-6 cables which you purchased, connect it between

the satellite dish LNB and the DBS IN port on the Combiner (SR2261) as

shown. (Refer to page 5 for the Combiner port identication.)

Combiner

Step 6

Step 7

Step 9Step 8

Splitter

Step 10

Multiswitch

Disconnect the existing cable run from the multiswitch and connect this end

of the cable to the COMBINED IN port on the Splitter (SR2251) as shown.

(Refer to page 5 for the Splitter port identication.)

Connect another of the RG-6 cables you purchased between the multi-

switch and the DBS TV port on the Splitter (SR2251) as shown. (Refer to

page 5 for the Splitter port identication.)

Connect another of RG-6 cables you purchased between the SIRIUS OUT

port on the Splitter (SR2251) and the F connector end of the supplied RG-

174 Adapter cable as shown. (Refer to page 5 for the Splitter port identica-

tion.)

Connect the other end of the RG-174 Adapter Cable to the ANT connection

on your SIRIUS radio as shown.

Verify that the satellite TV receiver/tuner is plugged into a working AC out-

let. Next, connect the provided AC Power Adapter to the POWER IN port of

the Splitter (SR2251), and plug it into a working AC outlet.

The installation is now complete.

10.