Home Signal Distribution Kit Installation Guide

33
Home Signal Distribution Kit Installation Guide
Disconnect the cable from the multiswitch and connect it to the COMBINED
OUT port on the Combiner (SR2261) as shown. (Refer to page 5 for the
Combiner port identication.)
Using one of the RG-6 cables which you purchased, connect it between the
multiswitch and the DBS IN port on the Combiner (SR2261) as shown. (Re-
fer to page 5 for the Combiner port identication.)
Step 6
Step 9Step 8
Splitter
S
M
C
Combiner
Multiswitch
Step 7
Step 10
Disconnect the existing cable run from the satellite TV receiver/tuner and
connect this end of the cable to the COMBINED IN port on the Splitter
(SR2251) as shown. (Refer to page 5 for the Splitter port identication.)
Connect another of the RG-6 cables you purchased between the satellite
TV receiver/tuner and the DBS TV port on the Splitter (SR2251) as shown.
(Refer to page 5 for the Splitter port identication.)
Connect another of RG-6 cables you purchased between the SIRIUS OUT
port on the Splitter (SR2251) and the F connector end of the supplied RG-
174 Adapter cable as shown. (Refer to page 5 for the Splitter port identica-
tion.)
Connect the other end of the RG-174 Adapter Cable to the ANT connection
on your SIRIUS radio as shown.
Verify that the satellite TV receiver/tuner is plugged into a working AC out-
let. Next, connect the provided AC Power Adapter to the POWER IN port of
the Splitter (SR2251), and plug it into a working AC outlet.
The installation is now complete.
4.
5.
6.
7.
8.
9.
10.