User Manual

13
be tilted in different directions. Adjust as necessary for your particular
vehicle. When the orientation is correct, tighten the knob.
4. Attach the Dash Mount to the PowerConnect
Vehicle Dock using the 4 provided screws.
5. Before you attach the Dash Mount to the
dash, skip ahead and finish the remainder of
the vehicle installation so that the cables are
attached to the dock.
6. Once the cables have been attached to the
dock, clean the mounting surface in the vehicle
with the alcohol preparation pad and let it dry
thoroughly.
7. Peel off the adhesive liner. Position,
press, and hold the Dash Mount in
place for 30 seconds.
IMPORTANT! Allow the Dash Mount
adhesive to cure (dry) for a minimum of
2-4 hours before using the mount. The
best adhesion occurs after 24 hours.
TIP! To remove the Dash Mount, carefully lift the adhesive pad with your
fingers or a spoon. Warming the pad with a hair dryer for several minutes will
help soften the adhesive.
AUDIO
ANT
PWR
FM
Vehicle Installation
Knob Adhesive Foot
Dock Mounting Plate