User Manual

31
towards the front of the vehicle. Use a blunt plastic putty knife or
similar blunt tool to lift the plastic trim just enough to tuck the cable
under underneath. Avoid side airbag locations on back pillars and
above the doors. Airbag locations are marked with “SRS” logos. Be
careful not to crimp or cut the cable.
4. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console. Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls. Secure the excess cable with wire
ties (purchased separately).
5. Bring the end of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock.
6. Continue with “Step 5: Connect the Magnetic Mount Antenna and
Power
Connect Power Adapter” on page 33.
Pickup Truck
1. Use a blunt plastic putty knife or similar
blunt tool to lift the rubber molding
around the windshield and tuck the
antenna cable underneath it.
2. Continue tucking the cable underneath
the windshield molding around the
windshield to the lowest corner.
3. At the lowest corner of the windshield,
route the cable out of the windshield
molding and into the rubber weather
Vehicle Installation