Warranty

TROUBLESHOOTING

Problems Possible Causes Solutions

Pump fails to start No electricity > Check power source

Open circuit or poor connection > Check if there is an open circuit

Impeller is clogged > Inspect the impeller

Pump starts but stops Impeller is clogged > Inspect the impeller

immediately Motor abnormal > Repair the motor or replace

causing the motor The pump is picking up too much Place the pump on a concrete

protector to activate sediment > surface to prevent sediment

pickup

The pump's head and Impeller is worn > Replace impeller

pumping volume Hose may be clogged > Unclog hose, reduce # of bends

is low

Pump makesa noise Motor bearings may be worn > Replace bearings

or vibrates

THE NON- CLOGGING SOLUTION