Use and Care Guide

16
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
fluid or allow a fluid to flow inside them.
Corrosive or conductive uids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc. can cause a short
circuit.
WARNING
If any parts are damaged or missing, do not operate this product until
the parts are replaced.
Use of this product with damaged or missing parts
could result in serious personal injury.
WARNING
Always wear eye protection with side shields marked to comply with
ANSI Z87 .1.
Failure to do so could result in objects being thrown into your
eyes and other possible serious injuries.
Before each use, inspect the entire product for damaged, missing, or loose parts, such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
This lawn mower must be used only with the battery packs and charger listed below:
Battery Pack
Charger
2Ah 2.5Ah 4Ah 5Ah
SKIL BY519701
SKIL BY519702
SKIL BY519703
SKIL
BY519601
SKIL BY519603
SKIL SC535801
SKIL QC536001
SKIL SC5358B-02
NOTICE:
Please refer to the battery and charger manuals for detailed operating information.
Adjust the Cutting Height (Fig. 8)
WARNING
Do not at any time make
any adjustment to the
lawn mower without first stopping the
motor, removing both battery packs, and
waiting for the blade to stop rotating.
WARNING
Keep your feet away from
the deck when adjusting
its height.
The mower can be set to any of 6 cutting
heights between 1” (25mm) and 3” (75mm).
Choose the proper cutting height according to
the type and condition of the grass.
a. Move the cutting-height adjustment lever
outwards from the slots in the cutting-height
indication plate.
b. Move the cutting–height adjustment lever back and forth to select the desired setting. The
cutting height for each setting is listed as below:
Cutting Setting 1 2 3 4 5 6
Cutting Height 1” (25mm) 1-3/8”
(35mm)
1-3/4”
(45mm)
2-3/16”
(55mm)
2-9/16”
(65mm)
3” (75mm)
c. Once arriving at the desired cutting-height position, engage the cutting-height adjustment
lever back into the slot.
Fig. 8