Instructions

A memory profile is available for setting and storing pertinent information for up to

20 different program sets; each channel can store 10 program. Once a battery

program is stored into memory, it will be retained until changed again manually.

Recalling a program memory number makes the charger instantly ready to go!

If you do not wish to use the battery program memories, this charger can be

manually set before each use.

(1)

(2)

The following flowchart shows how the program is set manually:

BATT/PROGRAM

LiPo BATT

LiPo BALANCE

2.0A 11.1V (3S)

LiPo BALANCE

2.0A 11.1V (3S)

LiPo BALANCE

2.0A 11.1V (3S)

LiPo BALANCE

2.0A 11.1V (3S)

BATT/PROGRAM Select

Mode Select

Program Start

Press INC and DEC to go through all the programs and press

START/ENTER to enter LiPo BATT Program.

Battery Setting

Press INC and DEC to go through all the modes and press

START/ENTER to enter LiPo Balance Charge Mode.

Press START/ENTER, the present value will start to blink. Press

INC and DEC to change the value and press START/ENTER to

confirm your setting.

At the same time, the battery pack’s cell count will start to blink,

press INC and DEC to change the value and press START/

ENTER to confirm your setting.

Press and hold START/ENTER for 3 seconds to start the

program.

START/ENTER

> 3 Seconds

Lithium Battery Program (LiPo/LiFe/Lilon/LiHV)

· 14

D260