Angle Gauge Manual

SKYRC Angle Gauge Instruction Manual SKYRC Angle Gauge Instruction Manual
3. SKYRC Angle Gauge SKYRC Angle Gauge 4.
Measure Throw
1. Connect the modules, and choose Throw to enter the page.
2. Fix the reference module to the position where the surface of the model aircraft is referenced
3. Fix the left and right modules on the rudder surface to measure.
Note: The right-angle must face the outside of the rudder surface and be parallel to the edge of
the rudder surface.
4. Set the throw, measure the width of the rudder surface, and input the width and throw in reference
to the model aircraft manual.
5. Set the throw, measure the width of the rudder surface, and input the width and throw in
reference to the model aircraft manual.
ZERO
Left throw
0mm
左侧行程
0.4mm
Aileron width 30 mm
Up aileron 10 mm
Down aileron 10 mm
Elavator width 30 mm
Up elevator 10 mm
Down Elevator 10 mm
Flap width 30 mm
Up flap 10 mm
Name
Model one Elevator Reference: sensor - relative Throw Set throw
ZERO
Left throw
16.5mm
Right throw
17.2mm
Name
Model one Elevator Reference: sensor - relative Throw Set throw
We guarantee this product to be free of manufacturing and assembly defects for a period of one year from the time
of purchase. The warranty only applies to material or operational defects, which are present at the time of purchase.
During that period, we will repair or replace free of service charge for products deemed defective due to those
causes. This warranty is not valid for any damage or subsequent damage arising as a result of misuse, modifica-
tion or as a result of failure to observe the procedures outlined in this manual.
Note:
The warranty service is valid in China only.
If you need warranty service overseas, please contact your dealer in the first instance, who is responsible for
processing guarantee claims overseas. Due to high shipping cost, complicated custom clearance procedures to
send back to China. Please understand SkyRC can't provide warranty service to overseas end user directly.
If you have any questions which are not mentioned in the manual, please feel free to send email to [e-mail]
1.
2.
3.
WARRANTY AND SERVICE
2021.05
7504-1490-01
Working Voltage: 3.4-4.2V
Working Current: ＜10mA
Interface: Type C
Input Voltage: 5V
Input Current: 200-300mA
Low-voltage Protection:
＜3.4V (Flashes Red)
Measuring Accuracy: ±2
O
Throw Angle: ±0.1mm
Working Temperature: 0
O
C-40
O
C
Working Humidity:
5%-90% (No Condensation)
Storage Temperature: -10
O
C-50
O
C
Storage Humidity:
1%-75% (No Condensation)
Size: 48.1*25.6*12.6mm
Weight: ≈25g
RED warns that the maximum throw angle of the correspond-
ing wing is greater than the calibration range
GREEN indicates that the maximum throw angle of the
corresponding wing is within the calibration range
Constant Blue
Flashing Blue
App is connected and working
Standby, waiting to be connected
Flashing Red
Charging
LED Indicator
Name
Model one Elevator Reference: sensor - relative Throw Set throw
ZERO
Left throw
16.5mm
Right throw
17.2mm
Specifications