Owner Manual

T-joint

Warning

Decal

Warning

Decal

T-joint

Enclosure

door

the first spring

enclosure door

5.1

5.2

the first V-ring

the first hole

the first spring hole

T-joint

left side

If the Enclosure net and Jumping mat are pre-in-

stalled, follow below steps to assemble the Jumping

mat to frame.

Inspect the connection of Jumping mat and Enclosure

net, make sure all the V-rings are passed through the

corresponding net holes.

Place the Jumping mat(5) on clear ground inside the

frame. and then adjust the location of two warning

dacals to align the two T-joint in opposite direction

as shown.

Attach the first V-ring with a spring to the first spring

hole on left side of T-joint, and then attach the

opposite V-ring to the first spring hole on left side of

T-joint.

NOTE: Count exactly the quantity of V-rings and the

spring holes on frame top, make sure each of them are

corresponding.

NOTE: Make sure the encolosure door is lined up

over the T-joint. Failing to do so will cause

alignment to be off. See image below.