Owner Manual

Enclosure door

V-ring

Frame

5.3

5.4

T-joint

Attach the Spring as follows:

A: Hook one end of Spring into the V-ring sewn on Jumping

mat.

B: Hook a Spring Tool as shown to the free end of the Spring.

C: Pull the Spring until it reaches the frame.

D: Push the end of the Spring into a hole in the frame, then

unhookthe Spring Tool

CAUTION:

It is wise to wear leather gloves while attaching the springs.

Be careful where you place your hands as the Springs and

Frame joints can pinch.

NOTE: The smaller hook end should be placed within the

V-ring.

Attach another two lateral V-rings to frame holes in the

same way as 5.2

NOTE:

Count exactly the quantity of V-rings and the spring holes

on frame top, make sure each of them are corresponding.

NOTE:

There are 72 springs around the edge of Jumping mat(5)

and 72 holes around the top tube

Attach other V-rings to frame holes on left side of

T-joint or Socket in the same way as 5.2

Now there are12 V-rings attached to the Top tube. And 12

Springs have been used.