Owner Manual

Holes
12
7
Strap ring
Strap
10
12
Hole
14
Hole
A
12
Hexagon hole
10.
9
Leg
Socket
T-joint
Frame PAD
B
C
Enclosure door
11.
T-joint
Socket
11
9
9
Jumping mat
Leg
22
Follow below steps to attach Curved tube to cap:
A.
Identify the hexagon hole on the Pole Cap(12) with a
nut buried inside.
B.
Insert the Pole Cap(12) into one strap ring on the
topedge of net. Make sure the Hexagon hole side of the
cap is against the net, and the holes on both the strap-
ring and the caps are aligned.
C.
Hold the pole cap close to a Curved Tube(10), then
insert the Curved Tube(10) into the Pole Cap(12).
Make sure the holes on the curved tube, pole cap and
strap ring are aligned. then
Insert the M5x50mmbolt(14)
until it touches the nut in the Hexagon hole of the pole
cap, securing them together.
Repeat this step to assemble the remaining parts inthe
same way.
Start from the Enclosure door, lift one of the assembled
poles and then insert the Straight Tube(9) into the
vertical tube of Socket as shown.
Make sure the bent side of the enclosure poles
are facing toward the center of the trampoline.
NOTE:
The end of the Straight Tubes(9) are sharp, be
careful when assembling.
Repeat this process to assemble the remaining five
poles to the trampoline frame.
NOTE: If you’re having trouble inserting
enclosure pulls, we’ve found it helful to pull
back in the middle of the poles while placing
them in a T-socket.