Installation Guide

219
Repair Parts and Maintenance Guide
The information contained in this document is subject to change without notice.
1. Faucet DOES NOT function.
A. “Permanent Off” activated. Press button on faucet throat one time.
2. Faucet delivers water in an uncontrolled manner.
A. Faucet is not working properly. Contact Sloan Technical Support.
3. Faucet DOES NOT deliver any water when Sensor is activated.
INDICATOR: Solenoid valve produces an audible “CLICK.”
A. Water supply stop(s) closed. Open water supply stop(s).
B. Water supply stop strainer(s) clogged. Remove, clean, and reinstall
water supply stop strainer(s). Replace strainer(s) if required.
INDICATOR: Solenoid valve DOES NOT produce an audible “CLICK.”
A. Power failure (EAF-200 Models). Check power supply.
4. Faucet delivers only a slow flow or dribble when sensor is
activated.
A. Water supply stop(s) are partially closed. Completely open water
supply stop(s).
B. Water supply stop strainer(s) clogged. Remove, clean, and reinstall
water supply stop strainer(s). Replace strainer(s) if required.
C. Aerator is clogged. Remove, clean, and reinstall Aerator. Replace
Aerator if required.
D. Faucet is not working properly. Contact Sloan Technical Support.
5. Faucet DOES NOT stop delivering water or continues to drip after
user is no longer detected.
A. Faucet is not working properly. Contact Sloan Technical Support.
6. The water temperature is too hot or too cold on a faucet
connected to hot and cold supply lines.
A. Supply Stops are not adjusted properly. Adjust Supply Stops.
B. For models with integral mixing valve – Mixing valve is set improperly
for the water temperature desired. Rotate mixing valve handle
clockwise to decrease water temperature or counterclockwise to
increase water temperature.
As the user’s hands enter the beam’s
effective range, the beam is reflected
back into the sensor receiver and
activates the solenoid valve allowing
water to flow from the faucet. Water
will flow until the hands are removed
or until the faucet reaches its
automatic time out limit setting.
CARE AND CLEANING INSTRUCTIONS
DO NOT USE abrasive or chemical cleaners including
chlorine bleach) to clean faucet that may dull the luster
and attack the chrome or special decorative finishes.
Use ONLY mild soap and water, then wipe dry with clean
cloth or towel.
While cleaning the bathroom tile, protect the
faucet from any splattering of cleaner. Acids and
cleaning fluids will discolor or remove chrome plating.
When assistance is required, please contact
Sloan Technical Support at: 1-888-SLOAN-14 (1-888-756-2614).
TROUBLESHOOTING GUIDE OPERATION
Optima
®
EAF-200