User's Guide
Table Of Contents
- Important information
- Chapter 1: Welcome
- About this guide
- About the display
- Touch
- Writing, drawing and erasing
- Support for additional pens and tools
- iQ experience
- Display
- Audio
- Network connectivity
- Room computers and guest laptops
- Accessory slot
- Convenience panel
- Remote control and IR sensor
- Proximity sensor
- Ambient light sensor
- Temperature and humidity sensors
- Mounting hardware
- Accessory mounting points
- Identifying your specific model
- Accessories
- More information
- Chapter 2: Using basic features
- Chapter 3: Using the iQ apps
- Chapter 4: Connecting computers and other devices
- Chapter 5: Troubleshooting
- The display isn’t turning on
- The display is turning on when it shouldn’t
- The screen is blank or there’s a problem with the image on the screen
- There’s no sound or there’s a problem with the sound
- Touch isn’t working as expected
- The pens and erasers aren’t working as expected
- iQ apps aren’t working as expected
- SMART software on connected computers isn’t working as expected
- The SMART OPS PC module isn’t working as expected
- Contacting your reseller for additional support
CHAPTER 2
USING BASIC FEATURES
13 smarttech.com/kb/171415
No. Name Procedure
1 Power
l
Press to enter or exit Standby mode (see Waking up the
display and putting it back to sleep on page11).
l
Press and hold for four seconds to turn off the display.
l
Press and hold for 10 seconds to reset the display.
2 Volume increase Press to increase the volume (see Adjusting the volume on
page19).
3 Volume
decrease
Press to decrease the volume (see Adjusting the volume on
page19).
4
Freeze
Press to freeze and unfreeze the screen (see page20).
5
Screen shade
Press to hide screen contents behind a screen shade (see
Showing and hiding the screen shade on page20).
6 USB Type A
connector (×2)
Connect USB drives and other devices that you want to use
with the iQ experience or a connected computer (see
Connecting USB drives, peripherals, and other devices on
page33).
7 HDMI 3 input
connectors
Connect a computer or other input source to use with the
display (see page29).
The Power button indicates the display’s status:
Power button Display status
Off Not receiving power
Amber Standby mode
White Normal operating mode
Using the remote control
The display comes with one of two infrared remote control models. These models are similar,
except one has an additional share screen button.
The infrared remote control enables you to turn the display on or off, change the input source,
change the volume, access the display’s iQ apps, and more. You can also use the remote control
to open the on-screen menus and change the display’s settings.