User's Guide
Table Of Contents
- Important information
- Chapter 1: Welcome
- About this guide
- About the display
- Touch
- Writing, drawing and erasing
- Support for additional pens and tools
- iQ experience
- Display
- Audio
- Network connectivity
- Room computers and guest laptops
- Accessory slot
- Convenience panel
- Remote control and IR sensor
- Proximity sensor
- Ambient light sensor
- Temperature and humidity sensors
- Mounting hardware
- Accessory mounting points
- Identifying your specific model
- Accessories
- More information
- Chapter 2: Using basic features
- Chapter 3: Using the iQ apps
- Chapter 4: Connecting computers and other devices
- Chapter 5: Troubleshooting
- The display isn’t turning on
- The display is turning on when it shouldn’t
- The screen is blank or there’s a problem with the image on the screen
- There’s no sound or there’s a problem with the sound
- Touch isn’t working as expected
- The pens and erasers aren’t working as expected
- iQ apps aren’t working as expected
- SMART software on connected computers isn’t working as expected
- The SMART OPS PC module isn’t working as expected
- Contacting your reseller for additional support
CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES
30 smarttech.com/kb/171415
NOTES
l Install SMART software on any computers you connect to the display (see Installing and
using SMART software on page27).
l Your organization’s installers might have connected cables to the display and run the cables
behind a wall or under the floor to a desk or table where you can place your computer.
Viewing a connected computer’s input
Use the Input app to view a connected computer’s input on the display.
To view a connected computer’s input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled If iQ is disabled
Tap the Home button below the
screen, and then tap Input
.
OR
Press the Input button on the remote
control.
Tap the Home button below the
screen.
OR
Press the Home button
or the Input
button on the remote control.
The display shows thumbnails of the devices that are connected to the display’s inputs:
o
A gray thumbnail indicates no device is connected to an input.
o
A blue thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an
input.
TIP
If iQ is disabled and you want a computer’s input to appear whenever you wake up the
display, tap the star in the upper-left corner of the computer’s thumbnail.
3. Tap the computer’s thumbnail.