User's Guide
Table Of Contents
- Important information
- Chapter 1: Welcome
- About this guide
- About the display
- Touch
- Writing, drawing and erasing
- Support for additional pens and tools
- iQ experience
- Display
- Audio
- Network connectivity
- Room computers and guest laptops
- Accessory slot
- Convenience panel
- Remote control and IR sensor
- Proximity sensor
- Ambient light sensor
- Temperature and humidity sensors
- Mounting hardware
- Accessory mounting points
- Identifying your specific model
- Accessories
- More information
- Chapter 2: Using basic features
- Chapter 3: Using the iQ apps
- Chapter 4: Connecting computers and other devices
- Chapter 5: Troubleshooting
- The display isn’t turning on
- The display is turning on when it shouldn’t
- The screen is blank or there’s a problem with the image on the screen
- There’s no sound or there’s a problem with the sound
- Touch isn’t working as expected
- The pens and erasers aren’t working as expected
- iQ apps aren’t working as expected
- SMART software on connected computers isn’t working as expected
- The SMART OPS PC module isn’t working as expected
- Contacting your reseller for additional support
CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES
32 smarttech.com/kb/171415
TIP
You can install the SMART software that is included with the display on the OPS PC. For more
information on installing software, see Installing and using SMART software on page27.
Viewing the OPS PC module input
To view the OPS PC module input
1. Do one of the following:
If iQ is enabled If iQ is disabled
Tap the Home button below the
screen, and then tap Input
.
OR
Press the Input button on the remote
control.
Tap the Home button below the
screen.
OR
Press the Home button
or the Input
button on the remote control.
A screen appears, showing thumbnails of the inputs connected to the display, including the
OPS PC module.
TIP
If iQ is disabled and you want the OPS PC module’s input to appear whenever you wake up
the display, tap the star in the upper-left corner of the OPS PC module’s thumbnail.
2. Tap the OPS PC module input.
Connecting external displays
You can connect an external display to duplicate or extend the OPS PC module’s desktop.
For more information, see the SMARTBoard 6000S and 6000S Pro series interactive displays
installation and maintenance guide (smarttech.com/kb/171414).
Connecting USB drives, peripherals, and other
devices
The display includes two USB 3.0 Type-A receptacles on the convenience panel and one USB 3.0
Type-A receptacle on the connector panel. You can connect USB drives, peripherals (such as
keyboards), and other devices to these connectors and use the devices with the iQ experience,
connected computers, and devices installed in the accessory slot (such as the SMART OPS PC).