Installation Guide

Pg. 2
INSTALLATION INSTRUCTIONS - DRYER CORD
Electrical Connection (non-Canada) – 4-wire cord
4-wire receptacle
(NEMA type 14-30R)
w WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
1. Turn off power supply to outlet.
2. Remove the screw securing the terminal block access cover
in the lower corner on the back of the dryer.
3. Install a UL-approved strain relief according to the power
cord/strain relief manufacturer’s instructions in the power
cord entry hole below the access panel. At this time, the
strain relief should be loosely in place.
4. Thread an UNPLUGGED, UL-approved, 30-amp power
cord, NEMA 14–30 type ST or SRDT through the strain
relief.
5. Disconnect the internal (WHITE) dryer harness ground wire
from the (GREEN) ground screw next to the terminal block.
6. Attach the ground (GREEN) power cord wire to the cabinet
with the ground (GREEN) screw. Tighten the screw securely.
7. Move the internal dryer harness ground (WHITE) wire to the
terminal block and attach it along with the neutral (WHITE)
power cord wire conductor to the center SILVER-colored
terminal on the terminal block. Tighten the screw securely.
8. Attach the RED and BLACK power cord conductors to the
outer BRASS-colored terminals on the terminal block.
Tighten both screws securely.
w WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
9
. Follow manufacturer’
s guidelines for firmly securing the
strain relief and power cord, and complete the
continuity check.
10. Reinstall the terminal block cover.
NOTE
If a terminal screw falls during cord installation, it can be
retrieved in the terminal screw recovery slot below the
access panel (if provided).
Ground
(GREEN wire)
30-AMP
NEMA 14-30
Access
cover screw
Terminal
block
Line 2
(BRASS terminal)
Neutral
(SILVER terminal)
Line 1
(BRASS terminal)
Internal ground
(GREEN screw)
Install
UL-approved
strain relief here
Neutral
(WHITE wire)
Move internal ground (WHITE)
wire to neutral (SILVER)
terminal for 4-wire system
Neutral terminal
WHITE
neutral wire
BLACK
or RED
power wire
BLACK
or RED
power wire
GREEN
ground wire
GREEN
ground screw