Instruction Manual

11
Now is a good time to test the transmitter. The Smart Foal alarm has
a hardware alarm. There is a switch on the front of the base station box on the right hand side.
 Flick the Hardware Alarm switch so that it is ON
 Now turn the transmitter so that it is on its side.
After a few seconds the hardware alarm should start screaming. If it does, everything is working.
Remember to return the hardware alarm switch to your desired setting before you forget about it.
Position the WiFi base station somewhere in between your foaling yards and your WiFi router. Make sure
the base station stays within range of your WiFi network. The radio antenna is on a long cable to enable you
to position it somewhere convenient. Higher is better, outside is better. It has a magnetic base so you can
‘stick’ it to anything metallic like a metal drum, gutter, metal fence post etc.
The long antenna cable is meant to improve your reception by allowing you to put it up higher.
If you have the Antenna inside next to the base station then you will actually lose a bit of signal due to cable
losses. In this case, connect the antenna directly to the base station and remove the magnetic base.
Transmitter on its back
Hardware alarm switch is here
Transmitter on its side
Hardware alarm