Instruction Manual

7
WiFi Setup
To connect your WiFi Base station to your home WiFi network you need to tell it which
network you want to use and the password. To do this the base station will open an access
point called “Smart Foal”. The base station gives you a configuration portal in which you
can select your network. Once you have chosen your network and saved your password the
Smart Foal network will disappear and the base station will connect to your home WiFi
network.
Handy hint: if your Radio OK (pink) light is flashing, you are not in WiFi configuration mode.
The elements of the base station are shown in the diagram below.
First attach the antennae to your WiFi base
station.
 One antenna goes on the
WiFi port.
 Connect the other antenna
to the magnetic base.
 Connect the cable from the magnetic
base to the radio port.
Then assemble your power pack to use the adaptor that suits your country.
 Find the USB cable that came with your kit
 Insert the USB end into the power pack
 Plug the other end of the cable in to the base station via the port that says Power In.
 The Power OK light should then turn on.
Magnetic antenna base
with antenna attached