User's Manual

5.4.5. Partner Device
This feature serves 2 purposes.
In Server mode it shows the address of the last device to successfully bond and connect.
In Client mode, it shows the device to which the product will attempt to pair/connect.
A remote device address must first be entered into the “partner device” section before the product, configured in
Client mode, will be able to initiate any connections to that remote device.
Adding a partner device using this feature does not
stop remote devices bonding with ADAPTER
while it is in Server Mode.
========================================
========= Modify Bluetooth Settings ===========
========================================
Key [0] - MAIN MENU
Key [1] - Set Discoverability
Key [2] - Set Security Mode
Key [3] - Set Encryption
Key [4] - Set PIN
Key [5] - Set Partner Device
Key [6] - Set Client/Server
Key [7] - Set Local Name
Key [8] - Set Class of Device
Once a remote device has successfully partnered
with ADAPTER, no other Bluetooth device will be
able to connect until the pairing has been
cleared. The pairing can be expired either by
interacting with this menu option, or by invoking a
“short” reset by pressing the reset button.
After selecting option 5 from the “Modify
Bluetooth Settings” menu, the following menu is
displayed.
========================================
============ Set Partner Device ==============
========================================
Key [0] - PREVIOUS MENU
Key [1] - Add partner device
Partner Device: 000a-4f-00082d (not paired)
Selecting 0 immediately returns you to the
previous menu storing any changes you have
made.
If a remote Bluetooth device has previously
paired to the ADAPTER then this menu will
display the first time the “Set Partner Device”
menu is access.
Selecting option “1” brings up the following menu.
You should enter here the Bluetooth Address
(BD_ADDR) of the remote device you wish to pair
to followed by ENTER. This should be in the same
format as indicated on the products label (NAP-
UAP-LAP, for those of you who know)
========================================
=========== Set Partner Device ===============
========================================
Key [0] – PREVIOUS MENU
Key [1] - Add partner device
Enter the address of the partner device: 000a-4f-00082d (not
paired)
This will now refresh the menu with the address
just entered and changes the option to allow
removal of the entered device.
The option to remove this newly entered device
exists at this point should you have made a
mistake.
Enter the address of the partner device:
Once ADAPTER has successfully paired with the
remote device (or vice-versa) the menu will
update to give the user the option to expire the
pairing. This can also be achieved by performing a
“short” reset using the reset button.
Enter the address of the partner device: 000a-4f-00082d
STBTIOBxXXPARSM User Guide 2.8 © Copyright SMART Modular Technologies 2004 Page 15 of 30