User's Manual

This expiration only deletes the Link Key created
during pairing and doesn’ t remove the device
itself.
========================================
============ Set Partner Device ==============
========================================
Key [0] - PREVIOUS MENU
Key [1] - Remove partner device
Key [2] – Expire pairing
Partner device: 000a-4f-00082d (paired)
Selecting the option to remove the partner device
as below will remove both the link key created
during the pair, and it will remove the partner
device itself from the memory of ADAPTER.
All the settings in this section are applied with
immediate effect.
Pairing expired…
========================================
========== Set Partner Device ==========
========================================
Key [0] - PREVIOUS MENU
Key [1] - Remove partner device
Key [2] – Expire pairing
Partner device: 000a-4f-00082d ( not paired)
5.4.6. Client/Server
========================================
====== Modify Bluetooth Settings =======
========================================
Key [0] - MAIN MENU
Key [1] - Set Discoverability
Key [2] - Set Security Mode
Key [3] - Set Encryption
Key [4] - Set PIN
Key [5] - Set Partner Device
Key [6] - Set Client/Server
Key [7] - Set Local Name
Key [8] - Set Class of Device
After selecting option 6 from the “Modify
Bluetooth Settings” menu, the following menu is
displayed.
Selecting 0 immediately returns you to the
previous menu storing any changes; selecting
any other option will store the appropriate
configuration selection.
The default configuration of your ADAPTER is set to
“Server” operation. This means that the ADAPTER
will wait for devices to connect to it. Changing
this setting to “Client” will put the ADAPTER into
a state where it will attempt to connect to the
device contained in its internal database. This
remote device is entered into ADAPTER using
the previous menu option, or by pairing with the
ADAPTER from the remote device while
ADAPTER is in server mode.
========================================
============ Set Client/Server ===============
========================================
DEVICE MUST BE REBOOTED IN ORDER TO APPLY THIS SETTING
Key [0] - PREVIOUS MENU
Key [1] - Server (accepts incoming connections)
Key [2] - Client (initiates connections)
Client/Server: Server (accepts incoming connections)
It is this option that requires interaction if you
wish to configure 2 ADAPTER’s to communicate
to each other to create a “true” cable
replacement scenario.
Unlike most other Bluetooth settings, the ADAPTER
requires re-booting before this option will be
enabled, although it is recommended that the
modification of this setting is left until all other
configuration changes have been made.
STBTIOBxXXPARSM User Guide 2.8 © Copyright SMART Modular Technologies 2004 Page 16 of 30