User's Manual

5.3.3. Data bits
Unfortunately this setting cannot be changed. The adapter only supports the 8 data bit format. Thus there is not a
configuration menu option for this setting.
5.3.4. Parity
========================================
=========== Modify COMM Settings ==========
========================================
Key [0] - MAIN MENU
Key [1] - Set Baud Rate
Key [2] - Set Parity
Key [3] - Set Stop Bits
Key [4] - Apply COMM Settings
Selecting option 2 from the “Modify COMM
Settings” menu enters the Set Parity menu.
========================================
================ Set Parity ================
========================================
Key [0] - PREVIOUS MENU
Key [1] - NO parity
Key [2] - ODD parity
Key [3] - EVEN parity
Parity: NO parity - unapplied
The Set Parity menu is displayed. Selecting 0
immediately returns you to the previous menu
storing any changes you have made; selecting
any other option will store the appropriate
configuration selection. As shown below, your
configuration selection will not actually be
applied at this point.
Configuration changes are only applied when
option 4 (Apply COMM settings) is selected from
the previous “Modify COMM Settings” Menu.
5.3.5. Stop bits
Option 3 from the “Modify COMM Settings”
menu allows the user to change the Stop Bit
setting.
========================================
========== Modify COMM Settings ===========
========================================
Key [0] - MAIN MENU
Key [1] - Set Baud Rate
Key [2] - Set Parity
Key [3] - Set Stop Bits
Key [4] - Apply COMM Settings
========================================
============== Set Stop Bits ================
========================================
Key [0] - PREVIOUS MENU
Key [1] - 1 stop bit
Key [2] - 2 stop bits
Stop Bits: 1 stop bit - applied
Selecting 0 immediately returns you to the
previous menu storing any changes you have
made; selecting any other option will store the
appropriate configuration selection. As shown
below, your configuration selection will not
actually be applied at this point.
Configuration changes are only applied when
option 4 (Apply COMM settings) is selected from
the previous “Modify COMM Settings” Menu.
Unapplied settings are discarded during a reboot
of the ADAPTER.
STBTIOBxXXPARSM User Guide 2.8 © Copyright SMART Modular Technologies 2004 Page 9 of 30