Network Router User Manual

Page 23 of 74
intelligent wireless platform
airClient™ TOTAL 3416 User Guide
2. Under the Current Operational Mode settings, choose Bridge option. (Note: IP Mux
Enable/Disable options can be left as default for now. More on this will be covered in Bridge
Mode Configuration, covered in Section 2-9).
3. Click on Save to convert the unit to Bridge mode.
4. The Bridge Mode on sB3416 can be configured to operate in WDS and non-WDS modes. For all
the configuration settings in different Bridge Modes, refer to Section 2.9.
Figure 2-9 Changing Router/NAT Mode to Bridge Mode (sB3416-03 only)
2.8. Changing from Bridge to Router/NAT Mode (sB3416-03 Only)
This section is only valid for the sB3416-03 model. Follow the steps below to change the airClient TOTAL
from the Bridge mode to Router/NAT mode.:
1. From the navigation menu bar, click on Tools | System Configuration. The Operation Mode
screen will appear as shown below.
2. Under the Current Operational Mode settings, choose Router or NAT option.
3. Click on Save to reboot the unit and to convert the unit to Router/NAT mode.
4. To configure the Wired parameters, see Section 2.10.1
5. To configure the WLAN IP and Radio parameters, like SSID, see Section 2.10.2