Network Router User Manual

Page 31 of 74
intelligent wireless platform
airClient™ TOTAL 3416 User Guide
9. Set the Default Data Rate to set the data rate for transmitting beacons, broadcast and multicast
traffic. By default, this rate is set to 1 Mbps.
10. Select the Transmit power of the radio from the drop down menu.
11. Select the Preamble to be Long or Short. By default the preamble is set to Long.
12. Click on Save to reboot and for the settings to take effect. The unit will attempt to associate after
the Reboot.
Figure 2-17 airClient TOTAL Bridge Radio Settings – Non-Transparent bridging (sB3416-03 Only)
Note : In non-transparent bridging configuration, when airClient TOTAL is associated, the MAC
addresses seen on the AP Association table, will be the MAC address of the sB3416-03 device, and not
of the devices behind the sB3416-03 unit.