Network Router User Manual

Page 56 of 74
intelligent wireless platform
airClient™ TOTAL 3416 User Guide
Figure 3-4 airClient TOTAL Ethernet Bandwidth Control – IP address based (sB3416-03)
Follow the steps below to control the Bandwidth parameters on the Ethernet side, based on MAC
address:
1. From the navigation menu bar, click on Networking | Bandwidth Control.
2. In the Ethernet Bandwidth Control settings. click on the Enable Bandwidth BWC button to
enable the Ethernet bandwidth controlling feature.
3. To control the Ethernet BWC, based on the MAC address, enter a valid MAC Address of the PC
in the place shown in Fig 3.5, and keep the IP Address as 0.0.0.0
4. You can configure the upload and download limit separately (in kbps), as shown below in Fig 3.4
5. Click on the Add button to add the entry in the table below.
6. Click on Save to save the settings. The settings will take effect after the Reboot.