Installation Guide

Step 4: Lock long edge of plank by
inserting tongue into groove at an angle
and drop in place. Slide plank toward
end of previously installed plank until
the tongue just touches the groove.
BRIDGE
Step 6: Attach a scrap piece of oor to
bridge gap between ends of planks.
Step 5: IMPORTANT! Use hammer and
tapping block to tap long edge of plank
to ensure a tight t. ANY GAPPING CAN
COMPROMISE THE LOCKING SYSTEM!
BRIDGE
Step 7: Tap end of plank with hammer
and tapping block to lock ends of
planks together. Remove bridge and
continue towards wall until installing
the nal plank in the row. BE SURE TO
TAP ON EDGE OF VINYL SO AS NOT
TO DAMAGE LOCKING PROFILE.
Step 8: Use hammer and pull bar to lock
nal piece in row. Insert spacer at end of
row. Continue installation to nal row.
Step 9: Use hammer and pull bar to lock
long edges of planks on nal row.
INSTALLING UNDER DOOR JAMBS:
Step 1: Undercut space under door
jamb to allow plank to slide freely. Tap
long edge with hammer and tapping
block to lock long edge.
Step 2: Use hammer and pull bar to lock
short end of plank.
3