User Guide

LampLinc Owner’s Manual
Restoring Power to LampLinc
LampLinc stores all of its settings, such as Links to other INSTEON devices, On-Levels/Ramp Rates, etc.,
with non-volatile memory. Because settings are saved in this non-volatile memory, they will not be lost in
the event of a power failure.
In the event of a power loss LampLinc will automatically return the load to the brightness level it had
before power was interrupted.
Resetting LampLinc to its Factory Default Settings
The factory reset procedure can be used to clear the LampLinc memory of all INSTEON Links,
programmed On-Levels and Ramp Rates, X10 addresses, etc.
1) If you are using a Controller to control LampLinc, be sure to Unlink it from the Controller. See
Unlinking LampLinc from an INSTEON Controller.
2) If you are using LampLinc to control any Responders, Unlink them from LampLinc. See Unlinking an
INSTEON Responder from LampLinc.
3) Unplug LampLinc for about 10 seconds
4) While holding down the Set button, plug LampLinc back in, making sure not to let go of the Set button
LampLinc
will beep and its Status LED will turn on solid green
5) Continue to hold down the Set button for 3 seconds and then release
LampLinc
will double-beep and the load will turn on
Page 13 of 19