User Guide

LampLinc Owner’s Manual
X10 PROGRAMMING OPTIONS
LampLinc is X10 ready, meaning that it can respond to X10 commands from X10 controllers and send
commands to X10 devices. However, to operate LampLinc in X10 mode, you must first set up an X10
address. As it ships from the factory or after a factory reset procedure, LampLinc will not have an X10
address set up.
Setting the X10 Address
1) Set LampLinc to Linking Mode by pressing & holding the Set button until it beeps (3 seconds)
The LampLinc Status LED
will begin blinking green
The load
will flash once
You will have 4 minutes to complete the next step before Linking Mode automatically times out.
2) Using an X10 controller, send the X10 address you want to assign and the ON command three times
For example, to assign the address A1, you would send “A1 ON A1 ON A1 ON.”
3) Once LampLinc has received the sequence, it will exit Linking Mode
LampLinc
will beep and its Status LED will turn on solid green if the load is on or solid red if it is off
Removing the X10 Address
If you are no longer going to control LampLinc with an X10 address, it is very important that you Unlink it.
Otherwise, LampLinc will still respond to X10 commands and may cause LampLinc to turn on by itself.
1) Set LampLinc to Linking Mode by pressing & holding the Set button until it beeps (3 seconds)
The LampLinc Status LED
will begin blinking green
The load
will flash once
2) Set LampLinc to Unlinking Mode by pressing & holding the Set button until it beeps again (3 seconds)
The LampLinc Status LED
will begin blinking red
The load
will flash once
You will have 4 minutes to complete the next step before Unlinking Mode automatically times out.
3) Using an X10 controller, send the X10 address you wish to remove and the ON command three
times
For example, to remove the address A1, you would send “A1 ON A1 ON A1 ON”.
4) Once LampLinc has received the sequence, it will exit Linking Mode
LampLinc
will beep and its Status LED will turn on solid green if the load is on or solid red if it is off
Page 14 of 19