Installation Guide
TRIM & FASCIA 190, 440, 540 & 2000 SERIES
INSTALLATION
DO
• Prime and paint all exposed surfaces including all drip edges or where water will hang.
• Apply nish coat as soon as possible or within 180 days of application.
• Use paints and sealants that meet specications in the General Application Equipment section in this document.
• Follow the coating manufacturer’s application and maintenance instructions.
DO NOT USE
• Semi-transparent and transparent stains.
• Shake and shingle paints.
• Vinyl-based resin formulas such as vinyl acetate, PVA, vinyl acetate/acrylic copolymer paints.
CAUTION:
HANDLE PREFINISHED LP PRODUCTS WITH EXTREME CARE DURING STORAGE AND APPLICATION.
TOUCH UP ANY DAMAGE TO THE FINISH THAT MAY OCCUR DURING APPLICATION PER PREFINISHERS SPECIFICATIONS.
GENERAL REQUIREMENTS (CONTINUED)
Finishing Instructions
Cal. Prop 65 Warning: Use of this product may result in exposure to
wood dust, known to the State of California to cause cancer.
Louisiana-Pacic Corporation
414 Union St.
Nashville, TN 37219
www.lpcorp.com
www.lpsmartside.com
© 2016 Louisiana-Pacic Corporation. All rights reserved. LP and
SmartSide are registered trademarks of Louisiana-Pacic
Corporation. Printed in U.S.A.
NOTICE: Louisiana-Pacic Corporation periodically updates and
revises its product information. The information in this document
is subject to change without notice. To verify that this version is
current, call 800-450-6106.
LPZB0521 02/16
LP SmartSide Trim & Fascia
LIMITED WARRANTY
The Louisiana-Pacic Corporation (“LP”) LP® SmartSide® trim and fascia (the “Products”) limited warranty (the “Warranty”) applies only to
structures on which the Products have been applied, nished and maintained in accordance with the published application, nishing
and maintenance instructions in eect at the time of application. Products aected by a failure to follow such application, nishing or
maintenance instructions (“Aected Products”) will be excluded from coverage under the Warranty.
LP assumes no liability for any loss or damage caused by the Aected Products and is expressly released by the purchaser or
owner from any such loss or liability.
Any modication of the Warranty or the application, nishing and maintenance requirements is void unless approved in writing by LP prior
to application.
For a copy of the warranty or installation and technical support, visit the LP Web site at: www.lpcorp.com
WARRANTY REMEDIES ARE NOT AVAILABLE IF REQUIREMENTS ARE NOT FOLLOWED. or for additional support call 800-450-6106
12