User's Manual

1
DOCSIS 3.0 Wireless Gateway Installation Instructions
Copyright ©2013 SMC Networks. All rights reserved
All information contained in this documentation is subject to change without notice.
Important Safety Instructions
Read these instructions before you begin
When using your equipment, basic safety precautions should always be followed to reduce the risk of re,
electric shock, and injury to persons, including the following:
• Read and follow these instructions.
• Keep these instructions.
• Heed all warnings.
• Only use attachments/accessories specied by the manufacturer.
• Do not install near any heat sources.
• Clean only with a dry cloth.
• Do not block any ventilation openings.
• Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the
apparatus.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been
damaged in any way, such as when a power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
• Do not alter or disable the polarized or grounding-type (three-pronged) plug.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
SMC Wireless Gateway complies with applicable requirements for performance, construction, labeling, and
information when used in accordance with the instructions below:
WARNING: Risk of Shock
Mains voltages inside this unit. No user serviceable parts inside. Refer service to qualied personnel
only! Avoid using and/or connecting the equipment during an electrical storm, to avoid risk of electrocu-
tion.
AVERTISSEMENT: Risque d’électrocution
Tensions du secteur dans cette unité. Ne contient aucune pièce pouvant être réparée par l’utilisateur.
Tout entretien doit être effectué par du personnel qualié seulement!
• Do not use this product near water (i.e. wet basement, bathtub, sink or near a swimming pool, etc.) to
avoid risk of electrocution.
• Avoid using and/or connecting the equipment during an electrical storm, to avoid risk of electrocution.
• Do not locate the equipment within 6 feet (1.9m) of a ame or ignition source (i.e. heat registers, space
heaters, replaces, etc.).
• Only use power supply and power cord included with the equipment.
• Equipment should be installed near the power outlet and should be easily accessible.
• The shield of the coaxial cable must be connected to earth (Grounded) at the entrance to the building
in accordance with applicable national electrical installation codes. In the U.S., this is required by NFPA
70 (National Electrical Code) Article 820. In the European Union and in certain other countries, CATV
installation equipment bonding requirements are specied in IEC 60728-11, Cable networks for television
signals, sound signals and interactive service, Part 11: Safety. This equipment is intended to be installed
in accordance with the requirements of IEC 60728-11 for safe operation.
• In areas of high surge events or poor grounding situations and areas prone to lightning strikes, additional
surge protection may be required on the AC, and Ethernet cables.
Rev 1.1
Nov 2013