- SMC9452TX-1 EZ CardTM Copper Gigabit PCI Card User Guide

9
PCI Configuration
In most cases, your network card is automatically configured when you power-up your computer. In certain
computers, however, you must modify PCI settings by running your computer’s BIOS Setup program. For more
information, refer to “PCI Compatibility” section of this manual.
Connecting Category 5 Cable
To connect to a 1000BASE-T Gigabit Ethernet device, use the RJ-45 connector on the network card and
Category 5, 5e or better UTP cable. This connection can be made directly to the device, or indirectly via a wall
outlet that has the proper wiring for an RJ-45 connector. Connections can be made for a distance of 100m (328
ft). It is recommended that for all critical connections, or any new cable installations, Category 5e (enhanced
Category 5) cable should be used.
Connecting UTP Cable
1. Attach the male RJ-45 connector on one end of a UTP cable to the network card’s RJ-45 port.
2. Attach the male connector on the other end of the UTP cable directly to an Ethernet, Fast
Ethernet or Gigabit Ethernet device. OR, attach the male connector on the other end of the
UTP cable to a wall outlet with an RJ-45 connector properly wired for 1000BASE-T Gigabit
Ethernet. Wiring from the wall outlet connection is usually routed to a hub or switch through
a punch-down block located in a wiring closet.
3. For 1000 Mbps operation, make certain that the device you are connecting to is compliant
with IEEE 802.3ab 1000BASE-T.