User's Manual

錯誤! 尚未定義樣式。
106
SMCD3GN2 Wireless Cable Modem Gateway Administrator Manual
1-to-1 Mapping Menu
Using the 1-to-1 Mapping menu, you can use the NAT to perform 1-to-1 mapping between
global IP addresses on the cable modem WAN interface and the private IP address on the
LAN.
To access the 1-to-1 Mapping menu, click NAT in the menu bar and then click the 1-to-
1 Mapping submenu.
Figure 54 shows an example of the menu. By default, 1-to-1 mapping is disabled. To enable
it, uncheck Disable NAT 1-to-1 Mapping Function and click Apply. To disable it, check
Disable NAT 1-to-1 Mapping Function and click Apply.
Note: The 1-to-1 Mapping submenu is not available in the menu bar if Enable
NAT Module is not checked in the NAT Settings menu (see page 91).