User's Manual

錯誤! 尚未定義樣式。

SMCD3GN2 Wireless Cable Modem Gateway Administrator Manual

2. Connect the other end of the cable to your computer’s network-interface card (NIC) or to

another network device (see Figure 4).

Figure 4. Connecting the Gateway to the a Laptop or Desktop Computer

Connecting the WAN

To connect the Gateway to a Wide Area Network (WAN) interface:

3. Connect a coaxial cable to the port labeled Cable on the rear panel of the Gateway from a

cable port in your home or office (see Figure 2 on page 14). Use only manufactured coaxial

patch cables with F-type connectors at both ends for all connections.

4. Hand-tighten the connectors to secure the connection.

Powering on the Gateway

After making your LAN and WAN connections, use the following procedure to power on the

Gateway:

1. Connect the supplied power cord to the port on the rear panel of the Gateway (see Figure

2 on page 14).

2. Connect the other end of the power cord to a working power outlet. The Gateway powers

on automatically, the POWER LED on the front panel goes ON, and the other front panel

LEDs show the Gateway’s status (see Table 1 on page 13).

WARNING: Only use the power cord supplied with the Gateway. Using a different

power cord can damage the Gateway and void the warranty.