User's Manual

錯誤! 尚未定義樣式。

SMCD3GN2 Wireless Cable Modem Gateway Administrator Manual

Using the Static Routes menu, you can add up to eight static routes, containing different

networks and subnets, to routers connected to the Gateway. The following example

describes how to configure a static route For example, assume that a router called SMC is

connected to the Gateway with subnet address 111.222.33.0 attached to it. Also, assume

that the router’s IP address in the Gateway subnet is 192.168.100.33. In this example, you

can add a static route named SMC, with a destination IP address of 111.222.33.0, a subnet

mask of 255.255.255.0, and a gateway IP address of 192.168.100.33.

Adding Static Routes

To add static routes:

1. In the Static Routes menu, click Add. The Add Static Routes menu in Figure 38 appears.

Figure 38 Add Static Routes Menu

2. Complete the fields in the Add Static Routes menu (see Table 18).

3. Click Apply. (Or click Back to return to the Static Routes menu or Cancel to cancel any

selections you made.) If you clicked Apply, the static route is added to the Static Routing

Table.

4. To define additional static routes (up to eight), repeat steps 1 through 3.

5. To change the settings for a static route, click the radio button to the left of the static route

you want to change and click the Edit button. When the Add Static Routes menu appears,

edit the settings as necessary (see Table 18) and click Apply.