User Guide

System Management Commands
7-11
7
show line
This command displays the console port’s configuration settings.
Command Mode
Exec
Example
The console port settings are fixed at the values shown below.
System Management Commands
These commands are used to configure the user name, password, system logs,
browser management options, clock settings, and a variety of other system
information.
Enterprise AP#show line
Console Line Information
======================================================
databits : 8
parity : none
speed : 9600
stop bits : 1
======================================================
Enterprise AP#
Table 7-4. System Management Commands
Command Function Mode Page
Country Setting
country Sets the access point country code Exec 7-13
Device Designation
prompt Customizes the command line prompt GC 7-15
system name Specifies the host name for the access point GC 7-15
snmp-server contact Sets the system contact string GC 7-42
snmp-server location Sets the system location string GC 7-43
Management Access
username Configures the user name for management access GC 7-16
password Specifies the password for management access GC 7-16
ip ssh-server enable Enables the Secure Shell server IC-E 7-17
ip ssh-server port Sets the Secure Shell port IC-E 7-17
ip telnet-server enable Enables the Telnet server IC-E 7-18
APmgmtIP Specifies an IP address or range of addresses allowed
access to the management interface
GC 7-22
APmgmtUI Enables or disables SNMP, Telnet or web management
access
GC 7-23
show APmanagement Shows the AP management configuration Exec 7-23